Embedded Files
In the SAM4 setup tool you can assign a DAQ to a motor.
Notice It is extremely important that the DAQ is linked to the correct motor ID. If you link an incorrect DAQ to the motor ID, the information of another DAQ will be shown in the system as the information for this motor ID.
Follow the next steps to assign a DAQ to a motor:
1. Navigate to the “DAQs” page in the top bar
2 Click the serial number of the DAQ you want to assign a motor to
3. Press the “Link motor” button in the motor information card. This page will take a few seconds to load
4. Select the location of the motor. A list of motor information is shown, please make sure this DAQ is indeed installed on the exact motor shown on screen
5 Press “Link motor”
Notice If the incorrect motor has been linked to a DAQ, use the “Unlink” button in the motor information card
If the motor is not available
If the motor is not showing up in the overview:
1. Please copy the exact DAQ serial number from this page in the SAM4 Setup Tool
2. Follow the instructions on Linking through the Onboarding portal
Page updated
Report abuse